This customizable electric actuator features a flat bottom and a front flange, offering a maximum thrust of approximately 300N (30 kg), suitable for industrial automation, intelligent equipment, and other applications.The following are technical specifications and customization points:
Rated thrust: 300N (customizable from 20 to 300N)
Stroke range: 10-100mm (customizable upon request)
Operating speed: 2-25mm/s (speed decreases with greater load)
Power supply voltage: 12/24/48V
Ingress protection: IP65 (normal splash water resistance)
Mounting method: Flat bottom + front flange (for easy mounting and connection)
Operating temperature: -20-45°C
Control methods: Limit switches, PWM ESC, remote control
Customization process
Drawing confirmation: Provide key parameters such as flat bottom dimensions, flange hole locations, stroke, and thrust.
Material selection: Stainless steel + copper alloy to meet corrosion resistance and strength requirements.
Performance optimization: Adjust motor power and reduction ratio based on load and speed. Inspection and Acceptance: Load testing, life cycle testing, and protection level testing are performed.
💡 Recommendation: Brushed DC motors are not recommended for high-frequency telescopic use.
Cost and Delivery
Custom quantities (≥2 units) have a delivery time of 15-25 days; small orders or special specifications will incur higher prices and lead times.
If requested, I can draw a flat-bottomed, flanged electric actuator installation diagram for quick integration with equipment. This ensures that mechanical interfaces and load distribution are fully considered during the design phase, avoiding time and cost associated with later modifications. Would you like me to prepare this drawing for you?
